We used the K&T as a cmm to make sure the column is square and perpendicular to the base..
http://electronicsam.com/images/greenmachine/20180831_162717.jpg On Sun, Apr 21, 2019, 10:33 PM John Dammeyer <[email protected]> wrote: > Speaking of mill alignment. It's been years since I did this and then I > didn't have the more accurate gauge. I did get an old brake disk surface > ground flat. That makes spinning the indicator around while tweaking so > much nicer. The photo shows the setup and then the gauge on the left and > right side of the brake disk. Close enough for jazz I think. > > http://www.autoartisans.com/mill/TrammedVertical.jpg > > John > > > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
