My G30 is setup to move in Z only. > -----Original Message----- > From: John Dammeyer [mailto:jo...@autoartisans.com] > Sent: Tuesday, September 24, 2019 5:59 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] G-Code issue with IJ > > > -----Original Message----- > > From: Ken Strauss [mailto:ken.stra...@gmail.com] > > > > It would certainly be shorter if they did a little looping! > > I'm unclear why they vary the feed with each segment. > > It does run on my LinuxCNC like a charm once I remove the request for the > unknown tool. Very smooth sounding. > > Also a bit scary each time when it heads over to Machine 0,0,0 at the end. > The G30. Wasn't expecting that. Thought it was maybe heading into the > bushes although so far my limit switches have worked well when I've screwed > up. > > John > > > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users