On Friday 18 October 2019 17:21:21 andy pugh wrote: > On Fri, 18 Oct 2019 at 19:38, Gene Heskett <[email protected]> wrote: > > grep-ing thru the git checkout. there is only a units.h, no module. > > So it is looking like I will have to re-invent this wheel, > > Do you keep all your emails? Perhaps you can find where you got it > from by searching back through them. twouldn't do much good Andy. I didn't have to search, it was just there. I /THINK/ I saw it in the Ducumentation pdf, it scratched an itch I had at the time, and now its gone. Poof! I think, if I can find the right switching signals from axis, that I can re-invent that knob with a couple scales and a mux4. But I've not found the switch signal either in my checking while running on the table. The new docs are nice, but gained 100+ pages too.
I'll need 2 status outputs, one from motion tallying machine g20-g21 mode, and one from axis, tallying view mode, inch or mm. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
