On Saturday 19 October 2019 08:26:17 Gene Heskett wrote: > On Friday 18 October 2019 17:21:21 andy pugh wrote: > > On Fri, 18 Oct 2019 at 19:38, Gene Heskett <[email protected]> > > wrote: > > > grep-ing thru the git checkout. there is only a units.h, no > > > module. So it is looking like I will have to re-invent this wheel, > > > > Do you keep all your emails? Perhaps you can find where you got it > > from by searching back through them. > > twouldn't do much good Andy. I didn't have to search, it was just > there. I /THINK/ I saw it in the Ducumentation pdf, it scratched an > itch I had at the time, and now its gone. Poof! I think, if I can find > the right switching signals from axis, that I can re-invent that knob > with a couple scales and a mux4. But I've not found the switch signal > either in my checking while running on the table. The new docs are > nice, but gained 100+ pages too. > > I'll need 2 status outputs, one from motion tallying machine g20-g21 > mode, and one from axis, tallying view mode, inch or mm. > > Cheers, Gene Heskett
As I posted on the lcnc forum just now, the rpi4 is now in the sheldon control box as of about 16:30 this afternoon and running that lathe well. Not w/o some mechanical and code drama though. Warm weather promised for tomorrow and I should get the video working then. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
