Hi Philip,
I'll download that one and see if it is the same as what I had.
did you use the GUI, txt installer or th live installer?
Ron
On 12/19/19 9:32 PM, Phillip Carter wrote:
I just downloaded the wheezy iso from
http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso
<http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso> and installed it
without any issues using the GUI install.
It does give a warning about the debian-security repo but that does not cause
any problems.
I was then able to run StepConf without any issues to create a stepper config.
Cheers, Phill
On 20 Dec 2019, at 1:36 pm, R C <[email protected]> wrote:
Hello all,
finally had some time to install the linux iso (LinuxCNC 2.7.14 Debian 7 Wheezy
<http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso
<http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso>>) again, I used the link
as mentioned earlier
(http://www.linuxcnc.org/downloads/ <http://www.linuxcnc.org/downloads/>)
<http://www.linuxcnc.org/downloads/ <http://www.linuxcnc.org/downloads/>>
I couldn't make any screen dumps, since nothing gets installed), but I took 2
pics.
The same ting happens in the gui install (as in the text install.)
thanks,
Ron
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
