I just downloaded the wheezy iso from http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso <http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso> and installed it without any issues using the GUI install.
It does give a warning about the debian-security repo but that does not cause any problems. I was then able to run StepConf without any issues to create a stepper config. Cheers, Phill > On 20 Dec 2019, at 1:36 pm, R C <cjv...@gmail.com> wrote: > > Hello all, > > finally had some time to install the linux iso (LinuxCNC 2.7.14 Debian 7 > Wheezy <http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso > <http://www.linuxcnc.org/iso/linuxcnc-2.7.14-wheezy.iso>>) again, I used the > link as mentioned earlier > > (http://www.linuxcnc.org/downloads/ <http://www.linuxcnc.org/downloads/>) > <http://www.linuxcnc.org/downloads/ <http://www.linuxcnc.org/downloads/>> > > > I couldn't make any screen dumps, since nothing gets installed), but I took 2 > pics. > > > The same ting happens in the gui install (as in the text install.) > > > thanks, > > > Ron > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
