also, on that Stretch installation. if you try to install on anyting
other then the first sata port, it names the device /dev/sde, even
though it is /dev/sda
I think the installer is broken, I have seen that earlier.
Ron
On 12/19/19 8:05 PM, Dave Matthews wrote:
Odd, Stepconf ran fineon the one I did.
Dave
On Thu, Dec 19, 2019, 21:54 R C <cjv...@gmail.com> wrote:
because a bunch of people were recommending it.
Also, I managed to install "LinuxCNC Uspace 2.7.0 Debian 9 Stretch"
<http://www.linuxcnc.org/testing-stretch-rtpreempt/>
BUT: there are two issues with that.
1: It does not want to install if there is more than one drive in the
system, which I can dodge by turning other drives off in the BIOS
2: There are issues with pyton, it is trying to use something that is
not there, files missing, when I start the "stepper config"
Ron
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
