The .4mm wide “tongue” you describe could be support structure automatically put there by the Cura slicer. You should be able to control how/if/where these are placed.
> On Jun 3, 2020, at 11:18 AM, Gene Heskett <[email protected]> wrote: > > On Wednesday 03 June 2020 11:23:08 Gene Heskett wrote: > >> On Wednesday 03 June 2020 10:33:28 andy pugh wrote: >>> On Wed, 3 Jun 2020 at 15:26, Gene Heskett <[email protected]> > wrote: >>>> Question, cura hasn't an obvious line feed speed, >>>> >>>> It's in the "Speed" section of the settings. >> >> I'll look again the next time I run it, I'd assume 20% low is ok, but >> 2% high can be trouble? So don't get carried away going up. >> >> >> Cheers, Gene Heskett > > And I just found something else that is a show stopper. That isn't "raft" > thats blocking the nut entry! it left a tongue the width of the nut, and > about .4mm thick, centered in the height of the nut channel, and > blocking the nut insert hole all the way to the bottom. And it wasn't > in the preview, that was good. And this one is also doing it (leaving > or) forming a post up the middle of the 5mm access hole for the grub > screw. ??? > > The 8mm shaft hole is however an excellent fit. A20 lb push or pull puts > it on or pulls it off. > > And the so called 40mm hub is closer to 39.20mm and only about .1mm out > of round. For driving this BS-1, thats more than good enough for the > girls I've gone with. > > So, obviously this isn't a working model, yet... > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
