On Sunday 07 June 2020 01:21:39 Gene Heskett wrote:

I went back to the 12 tooth I'll use for the motor pulley on the BS-1 
clone, and made it with the newer configuration.

Surprise, no junk in the access hole or the nut pocket, but I'd increased 
the nut size to a 5mm nut, which left the outside wall a bit thinner 
than I'd like, so I'll add a couple mm's to the hub diameter.

But before I do that again, perhaps someone could give me better 
measurements for both its width and thickness for a std 5mm nut?

This pulley would be usable, but belt tension is going to be quite high 
as the teeth, at this diameter are rounded enough to allow it to hop. 
Its a good looking render other than that.  Would slowing the movement 
speeds down improve that?  Render time was just a few seconds over an 
hour, which is a huge improvement.

Adhesion problems are gone if the first layer is under .1mm thick.  Thats 
about onion skin if using a paper for gage.

Many thanks for all the help folks.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to