DO I read this as using 0.3mm line width? If the nozzle has a 0.4mm hole you must set the line width to 0.4.
Cura will run the extruders at a rate that pumps plastic to make a linewitdth x layerthickness x speed. So if you say 0.3 line, then it will pump out 3/4 as much plastic as required and move over 0.3 to print the next line and will mess up what it just printed. The 3mm wall and also explains your very long print times. I'm making usable 40T pulleys in one hour 10 minutes I would print with all default settings but do enable support "everywhere" as it will only be used if needed. At least until you get a good looking 5mm test cube. On Sat, Jun 6, 2020 at 10:34 AM Gene Heskett <ghesk...@shentel.net> wrote: > On Saturday 06 June 2020 13:01:32 andy pugh wrote: > > > On Sat, 6 Jun 2020 at 17:56, Gene Heskett <ghesk...@shentel.net> > > wrote: > > > > Here ya go Andrew. A bit fuzzier on the far side, > > > > > > Do you have any wall at all? That looks to be _all_ infill. > > To me too. > > > In "Quality" what is your > "Wall line width" =0.3 > > > and then in "Shell" what is your > "Wall thickness" =3.0mm > > and > "Wall line count" =10.0 > > Thanks Andy > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
