On Friday 07 August 2020 14:07:04 Thaddeus Waldner wrote: > I finally got to do a little troubleshooting and here’s what I found: > > Key response on the keypad is never as fast as the on-screen UI but it > is consistent. I’m guessing there’s about a 100-300 ms delay but > that’s just a guess. Could this delay be due to the fact that this is > a scanning keypad? What is the scan rate on > > Once the inverter starts, I get a LOT of noise on the SmartSerial > lines. The noise voltage is around 4v as measured from the 7i73 > ground but it spikes to higher than that. Frequency is about 40khz but > it’s not consistent.
Check the invertor for a ground that does not go directly to that single bolt or buss bar I preach about. If its connected to that bolt, lift it and see if its still grounded someplace else, and isolate it from that unwanted ground. Then hook it back up to the common bolt. The static ground line to the invertors PSU should go only to this bolt. The static ground in the power cord should go to this bolt. But only once if there are more than one power cord. In rare cases, the moving parts of the machine, such as the table and Z sled or knee should be jumpered to the machine frame, and that frame connected to this common bolt. Well oiled moving ways are not that great an ohmic connection if actively moving on a film of oil. > The noise on the 5v power supply line to the 7i73 is minimal. The 7i73 > and all its connected switches are grounded only through the board’s > connection to the 7i96 board. > > Would a shielded ethernet cable help? You could try it, but I'd have doubts. Shielding only grounded at one end. Both make a ground loop you don't need or want. > IHTH. > > On Jul 31, 2020, at 9:17 AM, andy pugh <bodge...@gmail.com> wrote: > > > > On Fri, 31 Jul 2020 at 15:15, Peter C. Wallace <p...@mesanet.com> wrote: > >> Also even with default sserial error management you could only have > >> 10 servo thread cycles (10 ms with a 1 ms servo thread) of delay > >> due to failed transactions before a sserial error popup would > >> occur. > > > > Maybe noise on the keyboard itself? Is the keycode pin a single > > clean transition? > > > > -- > > atp > > "A motorcycle is a bicycle with a pandemonium attachment and is > > designed for the especial use of mechanical geniuses, daredevils and > > lunatics." > > — George Fitch, Atlanta Constitution Newspaper, 1912 > > > > > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
