On Fri, 6 Nov 2020, andrew beck wrote:

Date: Fri, 6 Nov 2020 11:47:58 +1300
From: andrew beck <andrewbeck0...@gmail.com>
Reply-To: "Enhanced Machine Controller (EMC)"
    <emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] how to control lathe spindle with a mesa 7i77 card

just another question for peter

can you just confirm how the 7i77 and 7i77 spindle controls differ please.
and if I connect up a spinx1 board do I need flash a pin file into the 6i25
or should it just work with the stock 6i52x7i77 config regards

andrew

You would need firmware that has a PWMgen on the second 6I25 connector
(5i25_7i77_7i78.bit is one possibility)


On Fri, Nov 6, 2020 at 8:56 AM andrew beck <andrewbeck0...@gmail.com> wrote:

hey peter just a quick question on this spinx1 card

this looks just what I need  just want to confirm a few things

my fanuc drive takes a 0-10v signal.  10v comes out from drive and it has
a wiper and 0v just like a POT.  I know I can use a 7i76 easily to run it.

just checking that the spindx1 is the same idea.  I saw reference in the
manual to a 5-18v input voltage from drive.  since my input voltage is 10v
am I good to go?

the price is right on that little card and it looks perfect.  I might use
a spare 7i76 now with the 7i77 and replace it once make my next order of
mesa cards
regards

Andrew

On Tue, Nov 3, 2020 at 4:42 AM Peter C. Wallace <p...@mesanet.com> wrote:

On Mon, 2 Nov 2020, andrew beck wrote:

Date: Mon, 2 Nov 2020 22:31:32 +1300
From: andrew beck <andrewbeck0...@gmail.com>
Reply-To: "Enhanced Machine Controller (EMC)"
    <emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <
emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] how to control lathe spindle with a mesa 7i77
card

Thanks Jon.

I am controlling a 1988 fanuc velocity spindle drive.  And no Idea about
isolation.  Not keen to try it lol.  Really I just want a isolated 0-10v
virtual pot like the Mesa 7i76 has.  Otherwise I might daisy chain in a
7i76 just for the spindle io. but that is such a waste lol.


If you have a spare parallel expansion slot, you could use a SPINx1

Peter Wallace
Mesa Electronics



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users


Peter Wallace
Mesa Electronics

(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to