Hello! I am trying to figure out, how to set up HAL config for 6i25 card that will have 7i77 and 7i74 attached to it. I flashed it with 5i25_7i77_7i74.bit firmware. I did also --verify and it reports that board configuration verified successfully. Is this correct approach?
Then I am puzzled about pwmgens. I do not see tham in HalConfig. I suspect that they are replaced with analogout0, analogout1 etc. How do I connect them in HAL? Are they equivalent for pwmgen.n.value pins? Viesturs _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
