On Sat, 13 Feb 2021, Viesturs L?cis wrote:
Date: Sat, 13 Feb 2021 20:44:58 +0200
From: "[UTF-8] Viesturs L?cis" <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: [Emc-users] Some questions about 6i25 and 7i77+7i74 combo
Hello!
I am trying to figure out, how to set up HAL config for 6i25 card that
will have 7i77 and 7i74 attached to it.
I flashed it with 5i25_7i77_7i74.bit firmware. I did also --verify and
it reports that board configuration verified successfully. Is this
correct approach?
Then I am puzzled about pwmgens. I do not see tham in HalConfig. I
suspect that they are replaced with analogout0, analogout1 etc. How do
I connect them in HAL? Are they equivalent for pwmgen.n.value pins?
Yes, they are replaced by the analogoutN pins plus they have associated scaling
and bounding pins.
I would use pncconf to create a sample configuration which will illustrate the
pin connections and parameter setting. Also 'man sserial'
Viesturs
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
