We are have PIM-SM running on those blades, but we are at FW 07.66.04.0002
Chris Yingst - Consultant ECE - Networking | Network Security 207.619.4472 From: "[email protected]<mailto:[email protected]>" <[email protected]<mailto:[email protected]>> Reply-To: "[email protected]<mailto:[email protected]>" <[email protected]<mailto:[email protected]>> Date: Thursday, November 13, 2014 at 10:43 AM To: Enterasys Customer Mailing List <[email protected]<mailto:[email protected]>> Subject: [enterasys] Cannot enable PIM on N7 I have two identical N7 chassis switches at my two corporate offices. The only differences is two blades in my corporate office are 10/100 7H4382-49s and the 2 blades in the matching chassis at my DR site are 10/100/1000 7G4285-49. Both units are running the 6.12.08.003 firmware and I have the advanced routing license installed on both units. For some reason I can't run a ip pim command from the router config. It looks like nat, slb, and twcb are unavailable as well. Is this a limitation of the 7H4382 DFE? Joshua Sanders Asst. Vice President - Systems Operations Western Mutual Insurance Group PO Box 19626 | Irvine, CA 92623-9626 * --To unsubscribe from enterasys, send email to [email protected]<mailto:[email protected]> with the body: unsubscribe enterasys [email protected]<mailto:[email protected]> ________________________________ NOTICE - This communication may contain confidential and privileged information that is for the sole use of the intended recipient. Any viewing, copying or distribution of, or reliance on this message by unintended recipients is strictly prohibited. If you have received this message in error, please notify us immediately by replying to the message and deleting it from your computer. --- To unsubscribe from enterasys, send email to [email protected] with the body: unsubscribe enterasys [email protected]
