on 4/29/01 3:14 AM, Jim Davis at [EMAIL PROTECTED] wrote:
>>> It's soft plastic, you might try scraping it with a knife around the
> inside
>>> of the mounting area. Crude, but it sounds like you only need a little
> more
>>> clearance.
>>
>> Actually, it's worse than that, because the box tapers in like a
>> pyramid. I'd need to scrape a significant amount of plastic to
>> get it to fit as deeply as it is supposed to.
>
> My Omnibounce for my 380EX does not taper- well maybe a tiny bit, it's
> pretty well a straight opening. The 380EX slides in about 3/4 inch and
> bottoms on the plastic edge with a snug, but not tight fit. Perhaps the
> wrong one got put in your package, or it's a real bad casting (tapered
> sounds strange). I'd try another one before I ask for a refund. I somehow
> think the Omnibounce people would not try and sell a unit that doesn't fit.
> Course I could be wrong, and they made a real big mistake trying to pawn off
> units they already made for another model, that don't quite fit the 420. Let
> us know how it turns out please.
>
>
>
I was just wondering, since the Omnibounce is made of plastic, couldn't you
put the open end about half an inch in boiling water to get it warmed up and
then put it on you 420EX to expand the device slightly?
*
****
*******
***********************************************************
* For list instructions, including unsubscribe, see:
* http://www.a1.nl/phomepag/markerink/eos_list.htm
***********************************************************
