Sorry about the blank message. Pressed the wrong key. Bill,
I am far from an expert, but I am currently installing rudder pedals on my 415-C. Here is what I know (or think I know). The existing hand brake means that you do not need an additional hand brake. The foot brake can be retained. I have been advised that the foot pedal can be turned upside down so that it can be activated with your heal (or is it spelled "heel") and still use the rudder pedals. Apparently, the size of the pedal must be reduce to make clearance and an additional slot in the floor board is necessary when the foot pedal is inverted. This sounds like the best of both worlds to me. I hope that helps. If I didn't get that right, there is a wealth of experience in this group with the correct information. Thanks. Frank Nelson N51DV - 415C TOA/California > > Hi All; > > > > I am going to install rudder pedals in my 415C using the Univair kit. > > In the catalogue is says that one also needs the Hand Brake > > Installation Kit. But I already have a hand brake in addition to the > > foot brake. I had another 415(D) that had rudder pedals and the foot > > brake (and hand brake). Does anyone know if I can install rudder > pedals > > and keep the existing hand-foot brake that I have (which is the > > original stock set-up)? > > > > Thanks in advance. > > > > Bill Buhles > > Davis, CA > > N94157 > > >
