I usually pull it out when it's below 2000 RPM. The automatic carb
heat control comes on a bit lower than that, and I don't want to risk
it having partial carb heat on, which actually causes carb icing worse
than none at all!
Larry Snyder
Washington, MO
N99340
On Feb 18, 2009, at 7:40 PM, carl_lavon wrote:
My ASI only has a Vne mark on it and I was wondering at
(approximately)
what rpm rate would one apply the carb heat in a C75? I have been
pulling it at about 1800 rpm. Suggestions? Thanks!
Carl LaVon
N415CB '46 ERCO 415C
KJVY
