On Sat, Dec 17, 2005 at 01:08:00PM -0800, Alan Crandall wrote:
> > Run "dmesg" after you plug it in and see what the system reports when
> > the drive is inserted. You might post the last ~10-20 lines of the
> > output here and we'll be able to help a bit better. This will tell you
> > a lot about what it sees. "lsusb" run as root will also tell you a fair
> > amount about how functional the setup is.
[..]
> usb-storage: device found at 42
> usb-storage: waiting for device to settle before scanning
> Vendor: Maxtor 6 Model: L200P0 Rev: BAH4
> Type: Direct-Access ANSI SCSI revision: 00
> SCSI device sda: 398297088 512-byte hdwr sectors (203928 MB)
> sda: assuming drive cache: write through
> SCSI device sda: 398297088 512-byte hdwr sectors (203928 MB)
> sda: assuming drive cache: write through
> /dev/scsi/host167/bus0/target0/lun0: p1
> Attached scsi disk sda at scsi167, channel 0, id 0, lun 0
> usb-storage: device scan complete
That's success. Your drive is available as /dev/sda.
--
"We are what we repeatedly do. Excellence, therefore, is not an act,
but a habit."
-- Aristotle
_______________________________________________
EUGLUG mailing list
[email protected]
http://www.euglug.org/mailman/listinfo/euglug
