On 08/09/2010 11:10 PM, Eric Keerbs wrote:
I've had a couple of questions posed on my original post, so I'm
going to (perhaps) commit a breach of netiquette and answer all
at once. (Poor Ed will end up with answers to questions he did
not ask....)
First...I have two versions of fldigi on my system, 3.21.0AK and
3.20.12. The same behavior exists with both. NOTE that both were
compiled from source code, so it is possible that I do not have
one or more of the dependencies.
Second...it's been suggested using the "DTR" option - I can only
assume "DTR +12v" since the other option would use DTR for PTT,
and my SignaLink USB is handling that. I will have to do some
additional wiring on my homebrew interface to add the DTR, as I
have only wired three circuits, Rx, Tx, and Gnd. That's the
hazards of borrowing from other designers' recommendations.
Third...to Ed's question...the errors are:
W: rigCAT_getmode: Retries failed
W: rigCAT_getfreq: Retries failed
The port, baud rate, and whether you are using RTS or DTR to power your
interface should be the same in both.
You need to have Commands are echoed checked. Some users check RTS/CTS
flow control, if you have, uncheck it.
Set retries to 2, retry interval to 50, and write delay to 10.
Whose design did you follow for the CI-V interface ? I've seen just
about all ot them. They tend to be basically the same.
Ed W3NR
PS: There are no net police on this list....hi
_______________________________________________
fldigi-alpha mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/fldigi-alpha
