On 08/10/2010 09:28 AM, Eric Keerbs wrote:
Ed--
I have all of the suggested settings below, though I have been
playing with different values for retry interval, # of retries,
and delay to determine if this would change anything. So far,
no luck.
Go back to my suggested settings, increase the write delay in increments
of 10 and see what you get.
With no RTS/CTS or DTR/DSR lines, it did not make sense to
have any of those boxes checked.
Your are correct, none are needed.
The interface is based on one that I found on the web, which
was in turn based on one in the ARRL Handbook. I am using an
RS-232 chip with two Tx and two Rx sections. Wiring is as
follows:
- Radio to TTL Tx1, Tx2, and Rx1
- Computer to RS-232 Tx1 and Rx1
- Other devices to TTL Rx2
- RS-232 Tx2 wired to Rx2
Also, I am using an external wall-wart to a 5v regulator,
so no power is being pulled from the RS-232 interface.
Perfect choice for an interface. I built one usng the same schematic, so
we know its not the interface.
This design isolates the radio from the rest of the CI-V equip-
ment. I was having issues with the TTL signal being pulled to zero
volts when my radio and SteppIR were connected to the same Tx
and Rx inputs when I had the radio set to transceive on the
CI-V line.
Were you able to correct this problem ?
Eric
Now, when you built from source did you run ::
sudo apt-get build-deps fldigi
first ? Did you have any errors when you were building from source ?
You did uncheck use hamlib and check use rigCAT ?
You did click the red intialize after every change ?
You do have commands are echoed checked ?
The last 3 are the most overlooked items, I'm just verifying that you
did and have rechecked your settings.
Ed
_______________________________________________
fldigi-alpha mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/fldigi-alpha
