Hi Gerald, I have seen the same problem using XP/2.0.8/Flex 5KA. I have inserted an earlier email on the problem below. I am still trying to figure out if this is a software or hardware problem. I have a couple of test yet to run and if you have any suggestions I would be happy to try them, unfortunately the problem is intermittent so it makes harder to fix. Best regards, George W2GS
I am running PSDR 2.0.8/XP/3.3.2.8028. Occasionally after I transmit the receiver noise level sensitivity drops to -150 on the pan adapter with the received signal going down with it. Normally at my station the noise level sensitivity is in the -115/-120 range. I have noticed that when this happens if I turn the preamp off the signal noise level rises to -135. When the unit is operating properly turning the preamp on and off has no effect on the noise level. I have done the following to try and fix the problem: started/stopped PSDR with no change in sensitivity (stays at -150), shutdown PSDR, the computer and the radio itself and restarted no effect, along the way I have reset the data base a number of times. When this problem occurs transmit is not affected. Last night I was operating on 40M SSB and this happened I could not recover the receive sensitivity to where the rig was operable. This morning I re-started everything and operation is normal. I then reset the data base and I am now waiting to see what happens. Any ideas as to what's going on? Thanks. George W2GS > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
