Dear Abd ul-Rahman Lomax,
"Abd ul-Rahman Lomax" <[EMAIL PROTECTED]> on 2001-06-13 12:59:12 AM reported
>If both pads have the same name in the footprint, and the pads do not have
>any net assignment, Update or Netlist load will assign both of them the
>same net. So far, so good. But Updating again or loading a Netlist again
>will *remove* both net associations. And if one has the net and the other
>is no-net, each load will swap the associations.
I've never seen this after I installed Protel service pack 6.
I have several footprints that have multiple pads associated with the same pin
number.
When I do ``Update PCB'', Protel does the Right Thing -- all those pads get
associated with the same net. Then when I ``Update PCB'', Protel does the Right
Thing again -- those pads are not in the ``preview changes'' list.
Do you have an example board/schematic
that still shows this behavior ?
Maybe Protel fixed this bug in service pack 6 ?
--
David Cary
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
