ok
-----Original Message-----
From: Bruce admin [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, 30 May 2001 12:57 AM
To: Protel EDA Forum
Subject: [PEDA] Copper/Thru hole DRC errors
I have run into a situation where I have a thru hole component that needs
surface mount pads associated with them also. I have created the component
in the library and then attached copper pads to the same area as the thru
hole pads. When I import the component into the PCB layout I get design
errors associated with it. Does anyone know how to overcome this problem?
On another note, and in the same design, I have manually swapped power pins
on a component. One of the power pins should be connected to an internal
plane, but it will not connect properly (no thermal relief, copper pours
around the via). All of the power pins in the vicinity of this via connect
properly, however, nothing I do seems to work to get this via to connect.
Any thoughts on this one?
Cheers,
Bruce Williams, CET, CNE
Electronic Substrate Systems Inc.
Ph: (403) 251-7377
FAX: (403) 255-6132
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
