Hi chuck, Does the other ports in the same slot is working with 2402? Could you try by connecting a laptop to the SI-GT to confirm your port is working or not? Have you tried using an another patch cable? Probably it should be a port failure since you have tested all the combination.
-jith On Tue, Feb 24, 2009 at 4:30 AM, Chuck Ufarley <[email protected]> wrote: > Thanks, daniel-- > > But it's still blocking. Reloading the SI-GT, blocking. Trying "no span," > blocking. Trying "enable," blocking. Strange. I can't figure out what's > causing it. > > On Mon, Feb 23, 2009 at 10:59 AM, Daniel Kekai <[email protected] > > wrote: > >> On the GT go to the interface config on 4/9 and type in: >> >> >> >> no spanning-tree >> >> >> >> Then test again >> >> >> >> -daniel >> >> >> >> *From:* Chuck Ufarley [mailto:[email protected]] >> *Sent:* Friday, February 20, 2009 1:19 PM >> >> *To:* Daniel Kekai >> *Cc:* [email protected] >> *Subject:* Re: [f-nsp] Port state blocking? >> >> >> >> Thanks. At this point I'm just trying to get the ports to come up, so >> it's the simplest config in the world. 2402 connected via port 26 to SI-GT >> on port 4/9 with a crossover cable. It's 11.0 code, and it's worked in >> other machines, though I don't have any currently running that code. >> >> 2402: >> >> FES2402 Switch#sho run >> Current configuration: >> ! >> ver 04.0.00aTc1 >> ! >> ! >> ! >> ! >> ! >> ! >> ! >> ip address 192.168.0.64 255.255.255.0 >> ! >> ! >> ! >> ! >> ! >> ! >> end >> >> FES2402 Switch#sho int e 26 >> GigabitEthernet26 is up >> Link Error Dampening is Disabled >> Hardware is GigabitEthernet, address is 000c.db1d.4769 (bia >> 000c.db1d.4769) >> Configured speed 1Gbit, actual 1Gbit, configured duplex fdx, actual fdx >> Configured mdi mode AUTO, actual MDI >> Member of L2 VLAN ID 1, port is untagged, port state is FORWARDING >> BPDU guard is Disabled, ROOT protect is Disabled >> Link Error Dampening is Disabled >> STP configured to ON, priority is level0 >> Flow Control is config enabled, oper enabled, negotiation disabled >> mirror disabled, monitor disabled >> Not member of any active trunks >> Not member of any configured trunks >> No port name >> IP MTU 1500 bytes >> 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization >> 300 second output rate: 640 bits/sec, 1 packets/sec, 0.00% utilization >> 6461218 packets input, 423261535 bytes, 0 no buffer >> Received 4282 broadcasts, 21834 multicasts, 6424644 unicasts >> 0 input errors, 0 CRC, 0 frame, 0 ignored >> 0 runts, 0 giants, DMA received 6461218 packets >> 6746678 packets output, 1994941951 bytes, 0 underruns >> Transmitted 189434 broadcasts, 124538 multicasts, 6432706 unicasts >> 0 output errors, 0 collisions, DMA transmitted 6746678 packets >> FES2402 Switch#sho int bri >> >> Port Link State Dupl Speed Trunk Tag Priori MAC Name >> 1 Down None None None None No level0 000c.db1d.4750 >> 2 Down None None None None No level0 000c.db1d.4751 >> 3 Down None None None None No level0 000c.db1d.4752 >> 4 Down None None None None No level0 000c.db1d.4753 >> 5 Down None None None None No level0 000c.db1d.4754 >> 6 Down None None None None No level0 000c.db1d.4755 >> 7 Down None None None None No level0 000c.db1d.4756 >> 8 Down None None None None No level0 000c.db1d.4757 >> 9 Down None None None None No level0 000c.db1d.4758 >> 10 Down None None None None No level0 000c.db1d.4759 >> 11 Down None None None None No level0 000c.db1d.475a >> 12 Down None None None None No level0 000c.db1d.475b >> 13 Down None None None None No level0 000c.db1d.475c >> 14 Down None None None None No level0 000c.db1d.475d >> 15 Down None None None None No level0 000c.db1d.475e >> 16 Down None None None None No level0 000c.db1d.475f >> 17 Down None None None None No level0 000c.db1d.4760 >> 18 Down None None None None No level0 000c.db1d.4761 >> 19 Down None None None None No level0 000c.db1d.4762 >> 20 Down None None None None No level0 000c.db1d.4763 >> 21 Down None None None None No level0 000c.db1d.4764 >> 22 Down None None None None No level0 000c.db1d.4765 >> 23 Up Forward Full 100M None No level0 000c.db1d.4766 >> 24 Up Forward Full 100M None No level0 000c.db1d.4767 >> 25 Up Forward Full 1G None No level0 000c.db1d.4768 >> 26 Up Forward Full 1G None No level0 000c.db1d.4769 >> FES2402 Switch# >> >> SI-GT: >> >> ServerIronGT E-1#sho run >> !Building configuration... >> !Current configuration : 378 bytes >> ! >> ver 11.0.00TD4 >> ! >> module 1 bi-0-port-wsm6-management-module >> module 3 bi-jc-2-port-gig-module >> module 4 bi-jc-16-port-gig-copper-module >> ! >> context default >> ! >> aaa authentication web-server default local >> no enable aaa console >> telnet server >> username admin password ..... >> snmp-server >> ! >> interface ethernet 4/9 >> ip address 192.168.0.77 255.255.255.0 >> ! >> end >> >> ServerIronGT E-1#sho int e 4/9 >> GigabitEthernet4/9 is down, line protocol is down >> Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia >> 000c.dbb5.b668) >> Configured speed auto, actual unknown, configured duplex fdx, actual >> unknown >> Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING >> STP configured to ON, priority is level0, flow control enabled >> mirror disabled, monitor disabled >> Not member of any active trunks >> Not member of any configured trunks >> No port name >> Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation >> ethernet >> 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization >> 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization >> 6096 packets input, 507641 bytes, 0 no buffer >> Received 4256 broadcasts, 1838 multicasts, 2 unicasts >> 0 input errors, 0 CRC, 0 frame, 0 ignored >> 0 runts, 0 giants, DMA received 0 packets >> 0 packets output, 0 bytes, 0 underruns >> Transmitted 0 broadcasts, 0 multicasts, 0 unicasts >> 0 output errors, 0 collisions, DMA transmitted 0 packets >> ServerIronGT E-1#sho int bri >> >> Port Link State Dupl Speed Trunk Tag Priori MAC Name >> 4/1 Down None None None None No level0 000c.dbb5.b660 >> 4/2 Down None None None None No level0 000c.dbb5.b661 >> 4/3 Down None None None None No level0 000c.dbb5.b662 >> 4/4 Down None None None None No level0 000c.dbb5.b663 >> 4/5 Down None None None None No level0 000c.dbb5.b664 >> 4/6 Down None None None None No level0 000c.dbb5.b665 >> 4/7 Down None None None None No level0 000c.dbb5.b666 >> 4/8 Down None None None None No level0 000c.dbb5.b667 >> 4/9 Down None None None None No level0 000c.dbb5.b668 >> 4/10 Down None None None None No level0 000c.dbb5.b669 >> 4/11 Down None None None None No level0 000c.dbb5.b66a >> 4/12 Down None None None None No level0 000c.dbb5.b66b >> 4/13 Down None None None None No level0 000c.dbb5.b66c >> 4/14 Down None None None None No level0 000c.dbb5.b66d >> 4/15 Down None None None None No level0 000c.dbb5.b66e >> 4/16 Down None None None None No level0 000c.dbb5.b66f >> ServerIronGT E-1# >> >> On Fri, Feb 20, 2009 at 12:06 PM, Daniel Kekai < >> [email protected]> wrote: >> >> Send the output on the FES side interface and if possible the configs for >> both the GT and FES >> >> Also do you have this setup working with other GT's – FES? If so are you >> running the same code? >> >> >> >> -D >> >> >> >> *From:* Chuck Ufarley [mailto:[email protected]] >> *Sent:* Friday, February 20, 2009 11:17 AM >> *To:* Daniel Kekai >> *Cc:* [email protected] >> *Subject:* Re: [f-nsp] Port state blocking? >> >> >> >> It seems to be disabled. Should I enable it? This hasn't been an issue >> in past configs. >> >> ServerIronGT E-1#sho span >> >> Spanning-tree is not configured on port-vlan 1. >> >> Thanks again. >> >> On Fri, Feb 20, 2009 at 11:01 AM, Daniel Kekai < >> [email protected]> wrote: >> >> Check your spanning tree >> >> -D >> >> >> >> *From:* [email protected] [mailto: >> [email protected]] *On Behalf Of *Chuck Ufarley >> *Sent:* Friday, February 20, 2009 9:51 AM >> *To:* [email protected] >> *Subject:* [f-nsp] Port state blocking? >> >> >> >> This might be a silly question, but I can't get a port to come up on a >> ServerIron. I enabled the interface and connected it properly to a >> FES-X2402 switch, but the J-B16GC and the J-B2Gx ports just won't come up >> and forward. The cards have worked in other configs, but I can't get >> anything to come out of "blocking" mode. Here are the shows (any help >> greatly appreciated): >> >> ServerIronGT E-1#sho run >> !Building configuration... >> !Current configuration : 378 bytes >> ! >> ver 11.0.00TD4 >> ! >> module 1 bi-0-port-wsm6-management-module >> module 3 bi-jc-2-port-gig-module >> module 4 bi-jc-16-port-gig-copper-module >> ! >> context default >> ! >> aaa authentication web-server default local >> no enable aaa console >> telnet server >> username admin password ..... >> snmp-server >> ! >> interface ethernet 4/9 >> ip address 192.168.0.77 255.255.255.0 >> ! >> end >> >> ServerIronGT E-1#sho run >> !Building configuration... >> !Current configuration : 378 bytes >> ! >> ver 11.0.00TD4 >> ! >> module 1 bi-0-port-wsm6-management-module >> module 3 bi-jc-2-port-gig-module >> module 4 bi-jc-16-port-gig-copper-module >> ! >> context default >> ! >> aaa authentication web-server default local >> no enable aaa console >> telnet server >> username admin password ..... >> snmp-server >> ! >> interface ethernet 4/9 >> ip address 192.168.0.77 255.255.255.0 >> ! >> end >> >> ServerIronGT E-1#sho mod >> Module Status Ports Starting MAC >> S1: B0GMR WSM6 Management Module, SYSIF 2 M6, ACTIV 0 >> S2: >> S3: J-BxG2 JetCore Gig Fiber Module, SYSIF OK 2 000c.dbb5.b640 >> S4: J-BxGC16 JetCore Gig Copper Module, SY OK 16 000c.dbb5.b660 >> ServerIronGT E-1#sho int e 4/9 >> GigabitEthernet4/9 is down, line protocol is down >> Hardware is GigabitEthernet, address is 000c.dbb5.b668 (bia >> 000c.dbb5.b668) >> Configured speed auto, actual unknown, configured duplex fdx, actual >> unknown >> Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING >> STP configured to ON, priority is level0, flow control enabled >> mirror disabled, monitor disabled >> Not member of any active trunks >> Not member of any configured trunks >> No port name >> Internet address is 192.168.0.77/24, MTU 1518 bytes, encapsulation >> ethernet >> 300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization >> 300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization >> 991 packets input, 77378 bytes, 0 no buffer >> Received 581 broadcasts, 410 multicasts, 0 unicasts >> 0 input errors, 0 CRC, 0 frame, 0 ignored >> 0 runts, 0 giants, DMA received 0 packets >> 0 packets output, 0 bytes, 0 underruns >> Transmitted 0 broadcasts, 0 multicasts, 0 unicasts >> 0 output errors, 0 collisions, DMA transmitted 0 packets >> ServerIronGT E-1# >> >> +++++ >> >> Thanks much, everyone. >> >> >> >> >> > > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp > -- -Sujith
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
