I'll get back on mine in a day or so as its on an IBM blade server.
On Mon, 4 May 2015 7:39 pm Roger Pau Monné <roy...@freebsd.org> wrote:
> El 02/05/15 a les 17.43, Roman Bogorodskiy ha escrit:
> > Hi,
> > I'm trying to get Xen running and following these instructions:
> > https://wiki.freebsd.org/Xen
> > and
> > http://wiki.xen.org/wiki/FreeBSD_Dom0
> > I'm running two days old -CURRENT and ports. I've installed the
> > emulators/xen port and followed instructions in pkg-message.
> > I'm having some problems with console. I'm wondering if it's possible to
> > have X running on the same box running xen kernel?
> It should be, although I had issues while using the vesa driver with a
> FreeBSD Xen Dom0, mainly because Dom0 doesn't have access to the BDA and
> EBDA, I'm working on fixing this in Xen upstream.
> > My setup is as follows:
> > - Intel i5-4690 that supports IOMMU:
> > $ sudo acpidump -t|grep DMAR
> > DMAR: Length=128, Revision=1, Checksum=90,
> > $
> > - vm.max_wired=-1 in /etc/sysctl.conf
> > - xc0 "/usr/libexec/getty Pc" xterm on secure in
> > /etc/ttys
> > In loader.conf I have:
> > xen_kernel="/boot/xen"
> > xen_cmdline="dom0_mem=2048M dom0_max_vcpus=4 dom0pvh=1 com1=115200,8n1
> > guest_loglvl=all loglvl=all console=com1"
> So you are trying to use the serial console but you are not getting any
> output? If that's not the case, please drop the com1 parameter and set
> Do you have anything else in your /boot/loader.conf apart from this two
> > With this setup I get my system booted and at some point I can see a
> > login screen. When I type 'startx' the system freezes. Have to hard
> > reboot it to get working again.
> On which device do you get a login prompt? Is it xc0, ttyv0 or ttyu0?
> email@example.com mailing list
> To unsubscribe, send any mail to "
firstname.lastname@example.org mailing list
To unsubscribe, send any mail to