Hi,
Right. Look at the status code (0x83) - that's a LONG_LIMIT fail. So
it failed to transmit.
it fails to transmit even on OFDM/CCK non-11n frames, and that's kinda odd.
CAn you repeat the same with 11n disabled?
-a
On 20 February 2014 21:49, Alexandr <shur...@shurik.kiev.ua> wrote:
> Attached, thanks!
>
> 20.02.2014 21:59, Adrian Chadd пишет:
>> sysctl dev.iwn.0.debug=0x1 - turns on TX debugging
>>
>> Then, try associating
>>
>>
>> -a
>>
>>
>> On 20 February 2014 08:56, Alexandr <shur...@shurik.kiev.ua> wrote:
>>> Adrian, I recompile kernel with IWN_DEBUG. What I need else to setup?
>>>
>>> 19.02.2014 22:46, Adrian Chadd пишет:
>>>> Hm, that's really odd. Can you compile your kernel / iwn module with
>>>> IWN_DEBUG in your config file? That way we can do some transmit side
>>>> debugging.
>>>>
>>>> Thanks!
>>>>
>>>>
>>>> -a
>>>>
>>>>
>>>> On 19 February 2014 05:41, Alexandr <shur...@shurik.kiev.ua> wrote:
>>>>> 09.01.2014 09:29, Alexandr пишет:
>>>>>> By the way, it connects to my work Cisco and Linksys AP's (but only 11g)
>>>>>> without any problems...
>>>>>>
>>>>>> 09.01.2014 09:21, Alexandr пишет:
>>>>>>> No, wpa_passphrase didn't help me.
>>>>>>>
>>>>>>> 07.01.2014 15:23, Maciej Milewski пишет:
>>>>>>>> On 06.01.2014 15:28, Alexandr wrote:
>>>>>>>>> I simply changed key in this listing to "secret". Yes, I tried a very
>>>>>>>>> simple configuration, no luck:
>>>>>>>>>
>>>>>>>>> network={
>>>>>>>>> ssid="door"
>>>>>>>>> psk="secret"
>>>>>>>>> }
>>>>>>>> Try using wpa_passphrase:
>>>>>>>> man wpa_passphrase.
>>>>>>>> It should create correct psk.
>>>>>>>>
>>>>>>>>> 06.01.2014 16:24, Adrian Chadd пишет:
>>>>>>>>>> The passphrase 'secret' is too short for WPA.
>>>>>>>>>>
>>>>>>>>>> I gather it's not _that_, but is it long enough to meet WPA
>>>>>>>>>> reuirements?
>>>>>>>>>>
>>>>>>>>>> Have you tried removing the proto= and bssid lines? You don't
>>>>>>>>>> strictly
>>>>>>>>>> need them.
>>>>>>>>>>
>>>>>>>>>> Thanks!
>>>>>>>>>>
>>>>>>>>>> -a
>>>>>>>>>>
>>>>>>>>>>
>>>>>>>>>> On 6 January 2014 06:00, Alexandr <shur...@shurik.kiev.ua> wrote:
>>>>>>>>>>> Hello,
>>>>>>>>>>>
>>>>>>>>>>> I recently upgraded system on my laptop to current with a hope to
>>>>>>>>>>> get my
>>>>>>>>>>> wireless card working. Now it successfully recognized by kernel:
>>>>>>>>>>>
>>>>>>>>>>> iwn0: <Intel Centrino Wireless-N 2230> mem 0xf2d00000-0xf2d01fff
>>>>>>>>>>> irq 17
>>>>>>>>>>> at device 0.0 on pci3
>>>>>>>>>>>
>>>>>>>>>>> Unfortunately, I can't connect to my home access point:
>>>>>>>>>>>
>>>>>>>>>>> wpa_supplicant[519]: wlan0: CTRL-EVENT-DISCONNECTED
>>>>>>>>>>> bssid=54:e6:fc:e4:48:c4 reason=0
>>>>>>>>>>> wpa_supplicant[519]: wlan0: WPA: 4-Way Handshake failed -
>>>>>>>>>>> pre-shared key
>>>>>>>>>>> may be incorrect
>>>>>>>>>>> wpa_supplicant[519]: wlan0: CTRL-EVENT-SSID-TEMP-DISABLED id=0
>>>>>>>>>>> ssid="door" auth_failures=10 duration=30
>>>>>>>>>>>
>>>>>>>>>>> I tried different security settings (WPA-WPA2 + AES-TKIP), wireless
>>>>>>>>>>> modes, radio channels on my access point, the same error.
>>>>>>>>>>>
>>>>>>>>>>> # ifconfig wlan0
>>>>>>>>>>> wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0
>>>>>>>>>>> mtu 1500
>>>>>>>>>>> ether 68:5d:43:92:3a:88
>>>>>>>>>>> nd6 options=29<PERFORMNUD,IFDISABLED,AUTO_LINKLOCAL>
>>>>>>>>>>> media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
>>>>>>>>>>> status: no carrier
>>>>>>>>>>> ssid door channel 1 (2412 MHz 11g ht/40+)
>>>>>>>>>>> country US authmode WPA2/802.11i privacy ON deftxkey UNDEF
>>>>>>>>>>> txpower 13
>>>>>>>>>>> bmiss 10 scanvalid 60 bgscan bgscanintvl 300 bgscanidle 250
>>>>>>>>>>> roam:rssi 7 roam:rate 64 protmode CTS ampdulimit 8k
>>>>>>>>>>> -amsdutx amsdurx
>>>>>>>>>>> shortgi wme roaming MANUAL
>>>>>>>>>>>
>>>>>>>>>>> /etc/wpa_supplicant.conf:
>>>>>>>>>>>
>>>>>>>>>>> ctrl_interface=/var/run/wpa_supplicant
>>>>>>>>>>> ctrl_interface_group=wheel
>>>>>>>>>>> eapol_version=2
>>>>>>>>>>>
>>>>>>>>>>> network={
>>>>>>>>>>> ssid="door"
>>>>>>>>>>> bssid=54:e6:fc:e4:48:c4
>>>>>>>>>>> key_mgmt=WPA-PSK
>>>>>>>>>>> proto=WPA RSN
>>>>>>>>>>> psk="secret"
>>>>>>>>>>> }
>>>>>>>>>>>
>>>>>>>>>>>
>>>>>>>>>>> Other home devices connets to AP without problems. Can you point me
>>>>>>>>>>> how
>>>>>>>>>>> I can debug it?
>>>>>>>>>>>
>>>>> Hello!
>>>>> Now I have changed my home access point to new Zyxel Keenetic Giga II
>>>>> and see the same picture - it still cannot connect to AP in 11n mode:
>>>>>
>>>>> Feb 19 15:33:05 thinkpad wpa_supplicant[518]: wlan0:
>>>>> CTRL-EVENT-SSID-REENABLED id=1 ssid="Keenetic-4703"
>>>>> Feb 19 15:33:05 thinkpad kernel: wlan0: [10:7b:ef:54:c5:c4] station
>>>>> assoc via MLME
>>>>> Feb 19 15:33:05 thinkpad kernel: wlan0: [10:7b:ef:54:c5:c4] switch
>>>>> station to HT40 channel 2462/0x40480
>>>>> Feb 19 15:33:05 thinkpad wpa_supplicant[518]: wlan0: Trying to associate
>>>>> with 10:7b:ef:54:c5:c4 (SSID='Keenetic-4703' freq=2462 MHz)
>>>>> Feb 19 15:33:05 thinkpad kernel: wlan0: [10:7b:ef:54:c5:c4] recv auth
>>>>> frame with algorithm 0 seq 2
>>>>> Feb 19 15:33:05 thinkpad kernel: wlan0: [10:7b:ef:54:c5:c4] assoc
>>>>> success at aid 1: long preamble, short slot time, QoS, HT40 (+AMPDU)
>>>>> Feb 19 15:33:05 thinkpad kernel: wlan0: link state changed to UP
>>>>> Feb 19 15:33:05 thinkpad wpa_supplicant[518]: wlan0: Associated with
>>>>> 10:7b:ef:54:c5:c4
>>>>> Feb 19 15:33:05 thinkpad dhclient[2628]: send_packet: No buffer space
>>>>> available
>>>>> Feb 19 15:33:11 thinkpad last message repeated 2 times
>>>>> Feb 19 15:33:11 thinkpad kernel: wlan0: [10:7b:ef:54:c5:c4] recv
>>>>> deauthenticate (reason 15)
>>>>> Feb 19 15:33:11 thinkpad kernel: wlan0: link state changed to DOWN
>>>>> Feb 19 15:33:11 thinkpad wpa_supplicant[518]: wlan0:
>>>>> CTRL-EVENT-DISCONNECTED bssid=10:7b:ef:54:c5:c4 reason=0
>>>>> Feb 19 15:33:11 thinkpad wpa_supplicant[518]: wlan0: WPA: 4-Way
>>>>> Handshake failed - pre-shared key may be incorrect
>>>>> Feb 19 15:33:11 thinkpad wpa_supplicant[518]: wlan0:
>>>>> CTRL-EVENT-SSID-TEMP-DISABLED id=1 ssid="Keenetic-4703" auth_failures=13
>>>>> duration=60
>>>>>
>>>>> Is any way to restrict wlan0 to operate only in ht20? ifconfig wlan0
>>>>> channel 11:ht/20 didn't help
>>>>>
>>>>> P.S. If I simply switch AP to 11g-mode my laptop connects to it.
>>>>>
>>>>> _______________________________________________
>>>>> freebsd-wireless@freebsd.org mailing list
>>>>> http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
>>>>> To unsubscribe, send any mail to
>>>>> "freebsd-wireless-unsubscr...@freebsd.org"
>
_______________________________________________
freebsd-wireless@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-wireless
To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org"
