In a message dated 10/10/01 3:25:24 PM, [EMAIL PROTECTED] writes:
<< The other cable is free and that's the one I hope to use. My question is how should I set this hard drives juper setting? My options occording to the lable of the drive are master, slave, or single(no jumper used)? >> The default from the drive manufacturer is full device capacity and Master. Your G3 MT may or may not be able to support Slaves. All MT's, however, will support at least two EIDE devices ... Bus 0, Master (standard HD), and Bus 1, Master (standard CD-ROM). If your MT supports Slaves (Rev. 2 and Rev. 3 mobos only), then Bus 1 may have a Slave, which is often a Zip. The Apple Bus 0 cable is not long enough to support a Slave, therefore the MT doesn't directly support Bus 0, Slave. It is, however, possible to support Bus 0, Slave, with some EIDE "voodoo". -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Macintosh? Get free email and more at Applelinks! <http://www.applelinks.com>
