Try console=tty02,115200n8, It works on OMAP4 panda board for different kernel version. Thanks, Venkat Raju -----Original Message----- From: "Wang, Ning W" <[email protected]> Sent: Wednesday, February 6, 2013 8:23am To: "abhishek tejaswi" <[email protected]>, "ravi kumar" <[email protected]> Cc: "[email protected]" <[email protected]> Subject: Re: [Tizen General] Not able to get serial terminal after tizen fs mount.
Have you tried system console by using this kernel boot command line: console=ttyS0,115200n8 ? From: [email protected] [mailto:[email protected]] On Behalf Of abhishek tejaswi Sent: Tuesday, February 05, 2013 11:08 PM To: ravi kumar Cc: [email protected] Subject: Re: [Tizen General] Not able to get serial terminal after tizen fs mount. Hi Ravi, Thanks for the response. I have already made changes in inittab file as con:12345:respawn:/sbin/agetty -L 115200 ttyO0 vt100 where ttyO0 is used on serial port for TI platform. My problem is that the file system is mounting properly but only serial termina shelll is not getting prompted. The file system build is for armv7l which by default takes ttySAC2 for samsung exynos. ttyO0 is used for TI. Is there mismatch here? I mean I am waiting for response from ttyO0 but it is logging onto ttySAC2? Can you please tell me what kind of changes I need to make in order to build mic image for a TI platform? Thanks again for the help. On Tue, Feb 5, 2013 at 7:20 PM, ravi kumar <[mailto:[email protected]] [email protected]> wrote: Hi Abhishek, For enable serial console.. you have to Check in /etc/inittab file, serial console enabled or not. If it is not enable, then you should enable that line. Regards, Ravi On Tue, Feb 5, 2013 at 7:13 PM, abhishek tejaswi <[mailto:[email protected]] [email protected]> wrote: Hi all, I am trying to bring up Tizen on Ti platform. Currently I am able to compile the linux 2.6.37 kernel, created fs image using mic for armv7l. Kernel loads properly but file system initialization is not happening properly and hangs. After giving message Started Connection service [ OK ] Starting WPA Supplicant daemon... Started Login Service [ OK ] Started WPA Supplicant daemon [ OK ] eth0: no IPv6 routers present I want to get shell to debug the issues. Can anybody let me know how to get shell in tizen? I am using ttyO0 and giving the same as argument while booting up. I have attached the file for reference. Please help me solve the issue. Thanks _______________________________________________ General mailing list [mailto:[email protected]] [email protected] [https://lists.tizen.org/listinfo/general] https://lists.tizen.org/listinfo/general
_______________________________________________ General mailing list [email protected] https://lists.tizen.org/listinfo/general
