Hi,
I was trying to port Tizen 2.0 to my pandaboard ES. I
downloaded the Tizen images for the repo and copied it to the SD card. I
already had the MLO and Uboot for the same board and the kernel I compiled from
the source provided by
https://wiki.tizen.org/wiki/Tizen_IVI_Getting_Started_Guide_For_PandaBoard with
Tizen Config. The boot was successful, besides some issues in resolution. I can
slide unlock the menu and after that the controller gets stuck. I have checked
the log in serial out. The last log says " do_calibrate: mpu: Calibration
complete: Voltage Nominal...." . Please help me with this.
Thanks and Regards,
Akhil P
________________________________
Confidentiality Statement / Disclaimer : This message and any attachments is
intended for the sole use of the intended recipient. It may contain
confidential information. Any unauthorized use, dissemination or modification
is strictly prohibited. If you are not the intended recipient, please notify
the sender immediately then delete it from all your systems, and do not copy,
use or print. Internet communications are not secure and it is the
responsibility of the recipient to make sure that it is virus/malicious code
exempt.
The company/sender cannot be responsible for any unauthorized alterations or
modifications made to the contents. If you require any form of confirmation of
the contents, please contact the company/sender. The company/sender is not
liable for any errors or omissions in the content of this message.
________________________________
_______________________________________________
General mailing list
[email protected]
https://lists.tizen.org/listinfo/general
