Is your tach verifying that the RPMs are increasing and the speed is not? I
am not terribly clear on what you are experiencing, but it is possible it is
an assembly problem. One other thing, are you sure your tech did not tell you
the barnett clutch plates would drag? That has been my experience since the
70's. They make their plates a little thicker than stock and this produces
creeping of the bike while trying to sit still with the bike in gear, clutch
in and engine running. In any event, you generically said "all" the clutch
parts. Did you replace the inner and outer baskets, steel plates and clutch
springs too? The other thing too is since it is a hydraulic system, was the
clutch line bled after the new clutch parts were installed?
RSRBOB
