I did all bevels on my H12 -- the angles should be the same. The BEVEL angle is: * 15 degrees where roof cone edge meets roof cone edge (diagonal to ground when set up) * 30 degrees where roof cone edge meets base edge (parallel to ground when set up) * 30 degrees where base edge meets base edge (perpendicular to ground when set up)
The TOTAL angle is double these figures. Don't cut any of your bevels to 60 degrees or you'll be wasting costly R-MAX. On Wednesday, June 28, 2017 at 1:34:02 PM UTC-7, ken winston caine wrote: > > Am getting ready to cut my 4" thick polyiso for an H18. > > Vaguely recall seeing instructions somewhere in the last 10 years for > which angles to cut on which edges so that the walls fit together flush, so > the roof panels fit together flush, and so the bottom edge of the roof and > the "toprail" of the walls fit together flush. Not finding where those > angles are published now. > > Can anyone point me to those? > > Thank you. > -- You received this message because you are subscribed to the Google Groups "hexayurt" group. To unsubscribe from this group and stop receiving emails from it, send an email to hexayurt+unsubscr...@googlegroups.com. To post to this group, send email to hexayurt@googlegroups.com. Visit this group at https://groups.google.com/group/hexayurt. For more options, visit https://groups.google.com/d/optout.
