Howdy gra.fics I've got a fancy Coda 34" motorized desktop laminator sitting in a crate since yikes April, haven't unpacked nor used it yet. I know, I know, that un-use is a sin, but time's been tight.
In the meantime: I've been getting by fine for low-volume mounting with a 4" Rollataq applicator. I cut a piece of fomecore a few inches larger than the untrimmed print. I apply the rollataq to the fomecore. I go left to right, then top to bottom, to ensure good coverage. I lay the print upon it. I put sheets of 11x17 paper over the print and fomecore. Press everything down with a roller. Put a heavy box on top. Come back in 30 minutes. Remove box. Remove 11x17 paper sheets. Trim up using Logan matte cutter. Works WONDERFULLY. Not a single failure. Neither messy nor wasteful when following this protocol. Most excellent results. No separation, even when the print's curly-curly cuz it's from the end of the roll and I've had no time to flatten. Big bargain technique with excellent results and no spray to inhale. -- stan - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Stanley Krute Computer and Photographic Services email: [EMAIL PROTECTED] Website: http://groups.yahoo.com/group/HPDesignJet_Printers Post message: [email protected] Subscribe: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] List owner: [EMAIL PROTECTED] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/HPDesignJet_Printers/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/HPDesignJet_Printers/join (Yahoo! ID required) <*> To change settings via email: mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
