Phil, The two flat plates at the top of the printer stand should each have a single long screw pointing upwards, they hold the printer onto the plate and stop it from sliding around. The long screws go into a threaded insert in the base of the printer. The long screw has a plastic surround that looks like you might be able to use it to turn the screw, but it's smooth and so you can't use it like this. If you haven't got these then it's possible that you are missing some parts, you might need to order them as spares.
Let me know if you need more info, I can take a photo if it helps. F On 11/30/07, Phil Indeblanc <[EMAIL PROTECTED]> wrote: > > I measured the distance between the legs where the screws are supposed > to go, and its 31 inches. I looked under the printer and I don't see > anything that lines up. is there some adapter plate? I am temped at > getting some plywood and just sitting the printer on it, but I dont > want to do that as it isnt stable. can get pushed off, or slowly move > over time of printing? who knows...i rather fix it to the stand as it > was supposed to be. Any thoughts? > > >
