So I added control points, then went to the "Optimize" tab and clicked "Optimize now". Then I went to the "Stitcher" tab and clicked "stitch now" and there were errors.
I have attached the two images I am using for a demo. I put a control point at both ends of the squiggles. Any suggestions? David On Thu, Jul 7, 2011 at 3:53 PM, Carl von Einem <[email protected]> wrote: > Sure, that's usually one of the simple tasks. Either try one of the CP > detectors or set some Control Points manually and optimize. Just try it out. > If the images were shot with different cameras / lenses or from a different > point then don't forget to tell Hugin that each image uses a different lens > ("Camera and Lens" tab, "New Lens" button). > > Hope that helps, > Carl > > David Doria schrieb am 07.07.11 20:24: >> >> If I have two images that almost entirely overlap, can Hugin be used >> to register them? > > -- > You received this message because you are subscribed to the Google Groups > "Hugin and other free panoramic software" group. > A list of frequently asked questions is available at: > http://wiki.panotools.org/Hugin_FAQ > To post to this group, send email to [email protected] > To unsubscribe from this group, send email to > [email protected] > For more options, visit this group at > http://groups.google.com/group/hugin-ptx > -- You received this message because you are subscribed to the Google Groups "Hugin and other free panoramic software" group. A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/hugin-ptx
<<attachment: 2.png>>
<<attachment: 1.png>>
