Macro-Micro-Pico-Femto – You just don’t get it

When I was born, apparently, the nurse said, “Look at the balls on
that guy!”

As I went through life with these balls they have gotten me into and
out of a lot of trouble.

SADS-BPL Correlation is part of 3 litigation lawsuits. I have the
balls to do it. I have the balls to pull it off.

Any questions?

Good – Because it don’t look like anybody has the balls to do it.

I'm going to show "them" what happens when you piss off an Englishman.

On Apr 13, 6:21 pm, Trev <[email protected]> wrote:
> Vic- great that the problem of hum is being taken seriously now and thanks
> for highlghting your insights into BPL
> This is always worth a re read as it's hard to take in in one go.
> However, there is no connection  between the general case you make and any
> individual - UNLESS you can give the details of exposure, reaction to local
> KNOWN conditions of BPL etc.
> Restating the precursors to a condition doesn't make it apply everywhere.
> It wouldn't get anywhere in a court of law. Surely you know this?
>
>
>
> On Friday, 13 April 2012 13:47:10 UTC+1, Vic wrote:
>
> > Here ya go, being looked at right now by SADS associations worldwide.
> > And Josh I don't believe you've read any evidence that has been put
> > together.
>
> > Wherever BPL/B-PLC is operational in the power lines there is
> > REACTANCE at the mains frequency; either 50Hz or 60HZ dependent on
> > country.
> > In the USA, at 60Hz/120V, this reactance power level is between 60 and
> > 80dBC (observed). In countries with 50Hz/230 or 240V this reactance
> > power level is between 60 and 95dBC (observed). These are statements
> > of fact and were taken from power spectrum sample data.
> > A reactance power level of 60dBC equates to approximately **1KW/cm2;
> > 80dBC to approximately **10KW/cm2; 95dBC to approximately **40KW/cm2.
> > All of the above power levels are calculated at ground level under a
> > power line – Approximately 18 feet high/distance.
> > ** Using the formula: 10log10 (P X 1/0.001) = (nn)dBm (milliwatts)
> > A quick look at REACTANCE resultant subharmonic frequencies compared
> > to heartbeat/pulse rate:
> > 50Hz                        Octave
> > Note                        60Hz                Octave Note
> > Low        48.56Hz                G1                                
> > 58.2705Hz        Bb1
>
> > High        53.112Hz                A1/Ab1                                
> > 63.735Hz        B1
>
> > Low        1.44bps                                                1.73bps
> > High        3.735bps                                                3.112bps
>
> > Low        72bpm                                                        
> > 103.77bpm
>
> > High        224.1bpm                                                
> > 186.72bpm
>
> > Key: Hz = Hertz        bps = Heartbeats per Second                bpm =
> > Heartbeats per
> > minute
>
> > The below text is taken from the National Emergency Medical
> > Association website:
> >http://www.nemahealth.org/programs/healthcare/heart_rate_pulse.htm
> > Resting Heart Rate anywhere in the range of 60 - 90 is considered in
> > the normal range. Your Heart Rate will fluctuate a lot depending on
> > such factors as your activity level and stress level. If however, your
> > pulse is consistently above 90, you should consult with your
> > physician.
> > Example:
> > If you count 12 beats in the span of 10 seconds, multiply 12 X 6 = 72.
> > This means your Heart Rate or pulse, is 72 (or 72 beats per minute).
> > Target Heart Rate for an Athlete
> > Take 220 and subtract your age. This will give you a predicted maximum
> > heart rate.
> > For example, if you are 22 years old, subtract 22 from 220 (220 - 22 =
> > 198). This means that your maximum physiological limit as to how fast
> > your heart should beat is 198 beats per minute.
> > 27 years old: 220 – 27 = 193bpm, 33 years old: 220 – 33 = 187bpm, etc.
> > Conclusion:
> > The above chart shows that BPL/B-PLC derived mains-electricity
> > Reactance subharmonic frequencies and human heartbeat rate, across the
> > board, have very similar properties.
> > Regardless of how you compare the above data, the fact remains; should
> > someone be in the vicinity of a medium and above strength BPL/B-PLC
> > derived mains electricity reactance there is a high probability that
> > their heartbeat would be force-modulated to the high-power subharmonic
> > pulses.
> > In medical terms this is known as Ventricular fibrillation (V-fib or
> > VF) and is a condition in which there is uncoordinated contraction of
> > the cardiac muscle of the ventricles in the heart making them quiver
> > rather than contract properly. Ventricular fibrillation is the most
> > commonly identified arrhythmia in cardiac arrest patients.
>
> > On Apr 13, 7:10 am, Trev <[email protected]> wrote:
> > > I agree Josh. Unless there is direct evidence of previous problems with
> > EM
> > > effects etc. it won't help our case to blame any unfortunate young death
> > on
> > > this without data that would make it a high grade suspect
>
> > > The information is there to kill this "thing". Why isn't anyone doing
>
> > > > anything?
>
> > > > There are a lot of groups of people taking out legal complaints over
> > > > in the States now that they know what "it" is. Others who were going
> > > > after stopping the so-called "smart" meters have swung BPL info into
> > > > their litigation too.
>
> > > > C'mon everybody.

-- 
You received this message because you are subscribed to the Google Groups "Hum 
Sufferers" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to 
[email protected].
For more options, visit this group at 
http://groups.google.com/group/hum-sufferers?hl=en.

Reply via email to