The console address when I was using the OSA TN3270 was 0090. The console address when using ZVM 5.2 TN3270 is L00C3. I guess I'll try L00C3 and see what happens.
Thanks. ____________________________ Jim Hughes 603-271-5586 "There's no sense in being precise when you don't even know what you're talking about." John von Neumann ________________________________ From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On Behalf Of David Kreuter Sent: Friday, July 20, 2007 2:44 PM To: [email protected] Subject: Re: ZVM 5.3 - Z890 - Second Level Install Is 00C3 your console address? Are you sure? David -----Original Message----- From: The IBM z/VM Operating System on behalf of Hughes, Jim - OIT Sent: Fri 7/20/2007 2:37 PM To: [email protected] Subject: [IBMVM] ZVM 5.3 - Z890 - Second Level Install I am stumped. I have loaded the 530RES volume and trying to IPL. My virtual machine is defined as 64M, class BG, Machine XA. I did the terminal commode 3270. I did the system reset. I did the IPL 1002 CLEAR LOADPARM 00C3. I did not receive the SAL screen. It jumped past it and is now asking for input. The messge "H HCPSED6013A A CP read is pending." Is on the screen. The state is "RUNNING". I type COLD DRAIN NOAUTOLOG and press the Enter key. Its been a couple of hours with no movement. I've done this a few times with identical results. Two times my emulator session was connected via the OSA TN3270 service. Then I logged in using the ZVM 5.2 TN3270 service and the results are identical. What am I doing wrong? I am no getting the SAL screen. And it acts as if my response to COLD DRAIN NOAUTOLOG is not going anywhere. EXPLORE/VM is showing no dasd activity for any of my ZVM53 volumes. What a way to end the week.....<sigh> ____________________________ Jim Hughes 603-271-5586 "There's no sense in being precise when you don't even know what you're talking about." John von Neumann
