NO NO it is a virtual console
from your userid enter q cons
like this
q cons
CONS 0009 ON LDEV L0004 TERM START HOST TCPIP FROM 10.37.60.218
0009 CL A CONT NOHOLD COPY 001 READY FORM STD4
0009 TO OTSMUNS PRT DIST 6059 FLASHC 000 DEST OFF
0009 FLASH CHAR MDFY 0 FCB LPP OFF
0009 3215 NOEOF OPEN 2730 NOKEEP NOMSG NONAME
0009 SUBCHANNEL = 0004
your cons sole is 0009
good luck
Bill Munson
VM System Programmer
Office of Information Technology
State of New Jersey
(609) 984-4065
President MVMUA
http://www.marist.edu/~mvmua
Hughes, Jim - OIT wrote:
The console address when I was using the OSA TN3270 was 0090. The
console address when using ZVM 5.2 TN3270 is L00C3. I guess Ill try
L00C3 and see what happens.
Thanks.
____________________________
Jim Hughes
603-271-5586
"There's no sense in being precise when you don't even know what you're
talking about."
John von Neumann
------------------------------------------------------------------------
*From:* The IBM z/VM Operating System [mailto:[EMAIL PROTECTED]
*On Behalf Of *David Kreuter
*Sent:* Friday, July 20, 2007 2:44 PM
*To:* [email protected]
*Subject:* Re: ZVM 5.3 - Z890 - Second Level Install
Is 00C3 your console address? Are you sure?
David
-----Original Message-----
From: The IBM z/VM Operating System on behalf of Hughes, Jim - OIT
Sent: Fri 7/20/2007 2:37 PM
To: [email protected]
Subject: [IBMVM] ZVM 5.3 - Z890 - Second Level Install
I am stumped.
I have loaded the 530RES volume and trying to IPL.
My virtual machine is defined as 64M, class BG, Machine XA. I did the
terminal commode 3270. I did the system reset.
I did the IPL 1002 CLEAR LOADPARM 00C3.
I did not receive the SAL screen. It jumped past it and is now asking
for input. The messge "H HCPSED6013A A CP read is pending." Is on the
screen.
The state is "RUNNING". I type COLD DRAIN NOAUTOLOG and press the Enter
key. Its been a couple of hours with no movement.
I've done this a few times with identical results.
Two times my emulator session was connected via the OSA TN3270 service.
Then I logged in using the ZVM 5.2 TN3270 service and the results are
identical.
What am I doing wrong? I am no getting the SAL screen. And it acts as if
my response to COLD DRAIN NOAUTOLOG is not going anywhere.
EXPLORE/VM is showing no dasd activity for any of my ZVM53 volumes.
What a way to end the week.....<sigh>
____________________________
Jim Hughes
603-271-5586
"There's no sense in being precise when you don't even know what you're
talking about."
John von Neumann
