Mike, By private network, I'm assuming the clients are using non-routable IP Addresses (typically 192.168.x.x or 10.10.x.x). If this is the case, then each client needs to set the following registry key: in HKEY_CURRENT_USER\SOFTWARE\IPSWITCH\MESSENGER\VERSION1.0\SETTINGS, the value "Client Uses NAT" must be set to (integer value) "1" .
I hope this helps. If not, would you mind sending including your sysmmdd.txt log? This will help us pin down your issue. Pete Mourfield Ipswitch, Inc -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Mike Wiegers Sent: Wednesday, February 05, 2003 12:35 PM To: [EMAIL PROTECTED] Subject: [IpswitchIM_Forum] Clients on private network Server on Internet network Installed the demo on a valid internet ip and installed the clients on a private ip network segment. The clients can attach to the server but will be disconnected from the server after a length of time. Also the clients show the status of each other in "unknown state" and cannot send instant messages back and forth. You do get the messages when you log off and back onto the server. Can this setup exist without any changes to the private network? If not what changes need to take place? Thanks Mike Wiegers To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/IpswitchIM_Forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/Instant_Messenger/index.asp To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/IpswitchIM_Forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/Instant_Messenger/index.asp
