On Thursday 01 June 2006 01:38, Marcel Janssen wrote: > Some data attached below (state = not working, black image in mythTV) > If anything else is needed, please let me know.
Well, I just had the first sucessful boot today and have live TV after 1.5 hours of rebooting..... New data from the successful session attached below. To me it seems that the black image comes from the pvr-350 being set to radio instead of analogTV, but that's just what I see in it and I don't know how to force it to initialise to analogTV. btw: I see some decoder firmware loading issue, but I don't use the decoder, so don't care much about that now. Also, this firmware sometimes loads well...making me believe it's just luck again that this tie the other firmware loaded successfully. Regards, Marcel ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.6.2 (development snapshot compiled on Mon May 8 07:35:43 2006) loading ivtv: Linux version: 2.6.16-1.2111_FC5 686 REGPARM 4KSTACKS gcc-4.1 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based) ACPI: PCI Interrupt 0000:00:0d.0[A] -> GSI 16 (level, low) -> IRQ 18 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom 1-0050: Hauppauge model 48134, rev J347, serial# 7110286 tveeprom 1-0050: tuner model is LG TP18PSB01D (idx 47, type 28) tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04) tveeprom 1-0050: audio processor is MSP4418 (idx 25) tveeprom 1-0050: decoder processor is SAA7115 (idx 19) tveeprom 1-0050: has radio, has IR remote tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) saa7127 1-0044: saa7127 found @ 0x88 (ivtv i2c driver #0) msp3400 1-0040: MSP4418G-A2 found @ 0x80 (ivtv i2c driver #0) msp3400 1-0040: MSP4418G-A2 supports nicam and radio, mode is autodetect and autoselect nvidia: module license 'NVIDIA' taints kernel. ieee1394: Initialized config rom entry `ip1394' USB Universal Host Controller Interface driver v2.3 sd 0:0:0:0: Attached scsi generic sg0 type 0 ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) firmware_loading_store: unexpected value (0) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB total) firmware_loading_store: unexpected value (0) ivtv0: unable to open firmware v4l-cx2341x-init.mpg ivtv0: did you put the firmware in the hotplug firmware directory? ivtv0: failed to read mpeg decoder initialisation file v4l-cx2341x-init.mpg tuner 1-0061: type set to 28 (LG PAL_BG+FM (TPI8PSB01D)) ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 ivtv: ==================== END INIT IVTV ==================== ioctl VIDIOC_LOG_STATUS ok ivtv0: ================= START STATUS CARD #0 ================= tveeprom 1-0050: Hauppauge model 48134, rev J347, serial# 7110286 tveeprom 1-0050: tuner model is LG TP18PSB01D (idx 47, type 28) tveeprom 1-0050: TV standards PAL(B/G) (eeprom 0x04) tveeprom 1-0050: audio processor is MSP4418 (idx 25) tveeprom 1-0050: decoder processor is SAA7115 (idx 19) tveeprom 1-0050: has radio, has IR remote tuner 1-0061: Tuner mode: analog TV tuner 1-0061: Frequency: 184.25 MHz tuner 1-0061: Standard: 0x000000ff saa7115 1-0021: Audio frequency: 48000 Hz saa7115 1-0021: Input: Composite 4 saa7115 1-0021: Video signal: broadcast/DVD saa7115 1-0021: Frequency: 50 Hz saa7115 1-0021: Detected format: PAL saa7127 1-0044: Standard: 50 Hz saa7127 1-0044: Input: normal saa7127 1-0044: Output: S-Video + Composite saa7127 1-0044: WSS: disabled saa7127 1-0044: VPS: disabled saa7127 1-0044: CC: disabled msp3400 1-0040: MSP4418G-A2 rev1 = 0x0117 rev2 = 0x1242 msp3400 1-0040: Audio: volume 58950 msp3400 1-0040: Mode: AM (for carrier detect) msp3400 1-0040: Standard: 5.5/5.74 B/G Dual FM-Stereo (stereo) msp3400 1-0040: ACB: 0x0c00 ivtv0: ================== END STATUS CARD #0 ================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
