Hello all,
I regularly have problems with the pickit-3.(MPlab X IPE v 5.45) . Because it happens less often when I first start up my PC, connect the pickit to the PIC and put voltage on it and only then connect the USB cable, this is my base. Despite this, I get often messages that the voltage is insufficient, the PIC is not the right type or a wrong feedback occurs during programming. This can almost always be solved by restarting MPlab, or by first performing a read or an erase. Lately I've been working with 3.3V. Now I had a program under 3.3V and that didn't work at all after programming without errors. After I erased the PIC separately below 5 V, the program works again. I have two clones. One suddenly doesn't work at all under 3.3 V, but with the Pickit_minus (with modified firmware) on 5V. Can anyone tell me where to look for the cause of all this? regards Hans -- You received this message because you are subscribed to the Google Groups "jallib" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/jallib/1a2d433a-cbf2-4ee1-8aae-9963aa150f2en%40googlegroups.com.
