Just sent the order go through the process. If you have issues, then, we can set about resolving for you and the greater community. The new release has the new 16F180xx and 16F171xx chipfamily - we are waiting on the 16F181xx to arrive before we can add (as we have to test them!). Also, adding more PIC32Mxs at the moment. Always busy.
On Friday, 11 November 2022 at 17:59:56 UTC [email protected] wrote: > Hi Evan, > > I noticed indeed issues with PICkitminus that it sometimes recognizes > another PIC than the one that is installed. > > So in order to get rid of this - and other issues I encountered - I just > ordered your PICKitPlus software for my PICKit3 🙂. > > Kind regards, > > Rob > > ------------------------------ > *Van:* '[email protected]' via jallib <[email protected]> > *Verzonden:* vrijdag 11 november 2022 07:51 > *Aan:* jallib <[email protected]> > *Onderwerp:* [jallib] Re: PICKIT 3 problems > > As the real developer of PICKitPlus and the database that was plagiarized > by PK- I am the right person to help. > > When our database was copied the developer decided to change the order > that the chip families are searched. I wrote a detailed analysis for him > and he ignored. So, using PK- can apply the incorrect voltage your PCB > during startup. > > Which chip or chips have this issue? This will help me isolate the issue. > > Evan > > On Friday, 11 November 2022 at 06:43:29 UTC hans wrote: > > Hello all, > > I regularly have problems with the pickit-3.(MPlab X IPE v 5.45) . > > Because it happens less often when I first start up my PC, connect the > pickit to the PIC and put voltage on it and only then connect the USB > cable, this is my base. > > Despite this, I get often messages that the voltage is insufficient, > the PIC is not the right type or a wrong feedback occurs during > programming. This can almost always be solved by restarting MPlab, or by > first performing a read or an erase. > > Lately I've been working with 3.3V. Now I had a program under 3.3V and > that didn't work at all after programming without errors. After I erased > the PIC separately below 5 V, the program works again. > > I have two clones. One suddenly doesn't work at all under 3.3 V, but with > the Pickit_minus (with modified firmware) on 5V. > > Can anyone tell me where to look for the cause of all this? > > regards > > Hans > > -- > You received this message because you are subscribed to the Google Groups > "jallib" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/jallib/e74098b6-6d7d-45a6-ba6c-087cc51faadcn%40googlegroups.com > > <https://groups.google.com/d/msgid/jallib/e74098b6-6d7d-45a6-ba6c-087cc51faadcn%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "jallib" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/jallib/64b27e61-12c7-451c-85e4-5c743cb3b417n%40googlegroups.com.
