Hi Tim & Timothy All interesting stuff. When I did my latest as shown in the pic I measured the distance of the wave peak to peak,, it was 2.5 inches. After doing the first three runs. I returned the carriage back to the start by ( crank handle ) Then I wound the carriage forward 6 turns of the crank handle. ---Next I disconnected the leadscrew nut and pushed the carriage back to the start position,,, re-connected the nut and did the remaing three cuts. All good practice and fun Richard
On Friday, August 30, 2019 at 11:47:26 AM UTC+1, Tim Ziegler wrote: > > Seeing all this Wave, now I'm going to have to figure out how to do that. > And of course build the attachment. > Kind Regards, > > Timothy J. Ziegler > Ziegler WoodWork & Specialty > 14171 160th Ave. > Foreston MN 56330 > > 320-294-5798 shop > 320-630-2243 cell > > > On Fri, Aug 30, 2019 at 2:30 AM Tim <artma...@comcast.net <javascript:>> > wrote: > >> >> >> >> >> Personally, I like it. You want to increase the amplitude, but by how >> much? I’ll take a look at some possibilities that would give you 90° >> travel of the spindle. It would only be able to be used on longer pitches. >> >> >> >> If Bill nows already how much offset is needed, he could save me some >> time 😊 >> >> -- >> You received this message because you are subscribed to the Google Groups >> "Legacy Ornamental Mills" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to legacy-ornamental-mills+unsubscr...@googlegroups.com >> <javascript:>. >> To view this discussion on the web visit >> https://groups.google.com/d/msgid/legacy-ornamental-mills/5d68d0b0.1c69fb81.9cf02.a772SMTPIN_ADDED_MISSING%40gmr-mx.google.com >> >> <https://groups.google.com/d/msgid/legacy-ornamental-mills/5d68d0b0.1c69fb81.9cf02.a772SMTPIN_ADDED_MISSING%40gmr-mx.google.com?utm_medium=email&utm_source=footer> >> . >> > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/7fa99ae6-bc53-4a8c-ba6a-ddbc806c2748%40googlegroups.com.
