Raymond, Hmmm. I'm not at all sure about the ESCON part of that equation. I use UTS Global's CLAW driver, but I do _not_ know if it is ESCON attached, or uses some other connection type. I'll check with my VM folks to see if they know.
One question about your setup. Will you be running on VM, or in an LPAR? If you're running in an LPAR, getting the CLAW support bundled into your installation system will be a bit of a pain, to say the least. I just went through that with one of my colleagues in Australia. Not fun. If you're running on VM, you can temporarily set up your network to use VM's TCP/IP stack for network connectivity, and then download and install the CLAW driver on a fully-functioning system. Much easier by far. Mark Post -----Original Message----- From: Raymond Noal [mailto:[EMAIL PROTECTED]] Sent: Friday, September 20, 2002 1:14 PM To: [EMAIL PROTECTED] Subject: LINUX/390 Distributions and a TCPIP question LINUX/390 newbie here - Is there a list/web site that would give me URLs for all of the various distributions for downloading LINUX/390? (Marist, RedHat, etc, etc.) Does Linux/390 currently support a CLAW/SCTC connection (Cisco Router attached via an ESCON channel)? Thanks in advance for you help. Raymond E. Noal Lab Manager Hitachi Data Systems San Diego Facility Office * : (858) 537-3268 Cell m : (858) 722-1140 E-mail * : [EMAIL PROTECTED] <[EMAIL PROTECTED]>
