When I migrated to z/VM 5.4 I switched all vswitch, TCPIP, and all my SLES
guests to vswitch layer 2. All has worked fine.
Now I'm trying to install a new Sles10 for the first time since going to
layer 2. My first problem was my PARMLINE, found I needed to change
LAYER2=1. I also get prompted for a MAC ADDRESS> that I haven't before. The
installation went without incident until the point where the RPMs are
installed and you IPL from you boot disk for the first time.
Setting up network interfaces:"
lo "
lo IP address: 127.0.0.1/8 "
Checking for network time protocol daemon (NTPD): ..unused"
Can't determine current runlevel"
[1A..doneWaiting for mandatory devices: eth-id-02:00:85:00:00:09 __NSC__"
.
.
.
"
eth-id-02:00:85:00:00:09 No interface found"
[1A..failedSetting up service network
--
Mark Pace
Mainline Information Systems
1700 Summit Lake Drive
Tallahassee, FL. 32317
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
