I IPLed the install process. Connected using SSH. Started yast and went through the process to enable the DASD. Then connected on another SSH session and mounted my boot disk as /mnt cat /mnt/etc/sysconfig/hardware/hwcfg-bus-ccw-0.0.1d00 STARTMODE='auto' MODULE='' MODULE_OPTIONS=''
No LAYER2 support so I edit the file and add QETH_LAYER2_SUPPORT='1' IPL from the boot disk and get the same problem. On Thu, Feb 12, 2009 at 5:10 PM, Mark Post <[email protected]> wrote: > >>> On 2/12/2009 at 4:28 PM, Mark Pace <[email protected]> wrote: > > When I migrated to z/VM 5.4 I switched all vswitch, TCPIP, and all my > SLES > > guests to vswitch layer 2. All has worked fine. > > Now I'm trying to install a new Sles10 for the first time since going to > > layer 2. My first problem was my PARMLINE, found I needed to change > > LAYER2=1. I also get prompted for a MAC ADDRESS> that I haven't before. > The > > installation went without incident until the point where the RPMs are > > installed and you IPL from you boot disk for the first time. > > You might have run into an installer bug. Restart the installer, but use > SSH as your installation method. When you sign in, make sure the > QETH_LAYER2_SUPPORT='1' variable is set in your > /etc/sysconfig/hardware/hwcfg-qeth* file. If not, you should be able to add > it, unmount everything, and reboot from disk. > > > Mark Post > > ---------------------------------------------------------------------- > For LINUX-390 subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO LINUX-390 or > visit > http://www.marist.edu/htbin/wlvindex?LINUX-390 > -- Mark Pace Mainline Information Systems 1700 Summit Lake Drive Tallahassee, FL. 32317 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
