The enclosed appears to indicate Unsolicited Commercial Email was relayed
through your network.
Please investigate and take appropriate action.
Ronnie Hale wrote:
> On Fri, 18 Jun 1999, Wilson G. Hein wrote:
>
> > Hi Bob,
> >
> > > -----Original Message-----
> > > On Thu, Jun 17, 1999 at 10:16:31PM -0400, Wilson G. Hein wrote:
> > Original message cut
> > >
> > > What does 'cat ioports' say. Do the serial ports show up?
> >
> > cat /proc/ioports says:
> >
> > 0000-001f : dma1
> > 0020-003f : pic1
> > 0040-005f : timer
> > 0060-006f : keyboard
> > 0070-007f : rtc
> > 0080-009f : dma page reg
> > 00a0-00bf : pic2
> > 00c0-00df : dma2
> > 00f0-00ff : npu
> > 01f0-01f7 : ide0
> > 02f8-02ff : serial(auto)
> > 0300-031f : NE2000
> > 03c0-03df : vga+
> > 03f0-03f5 : floppy
> > 03f6-03f6 : ide0
> > 03f7-03f7 : floppy DIR
> > 03f8-03ff : serial(auto)
> >
> > > The mainboard serial ports operate just like those on a card. You may
> > > have to go into the CMOS setup and set some parameters for them, like
> > > port address/IRQ (typically the choices are [dos] com 1-4, IRQ 4/3)..
> > > You should also probably designate those IRQ's as Legacy ISA, so pnp
>
> Wilson,
> One thing to check in your cmos setup... Make sure the onboard ioports
> are actually set for com1 and 2. I have one board here that defaults the
> onboard io-ports being on com3 and 4. Why, I don't know, but it can cause
> you a real headache until you find that little anomaly.
>
> --
> 73, Ronnie.
> [EMAIL PROTECTED]
