Hi!
On Sun, 12 Sep 1999, Michael J. Hoyt wrote:
> I installed my parport Ditto Easy3200 Tape drive on dual-bootable laptop
> under windows to see if could get an idea of what system resources the
> drive was using. The tape worked
...
> So I rebooted back to linux on this laptop and rebuilt and installed
> ftape. I get the same results as before.
>
> ftmt: /dev/qft0: Device not configured
>
> The modules are loaded, I have verified that.
>
I've got the same problem. I use an IOMEGA ditto 800 under Windows and it
works fine. But under Linux (Kernel 2.0.36) the insmod of ftape
4.03pre2 failed. The modules
are in the lsmod-list but with dmesg (these command prints the last
modulmessages) I found out, that bpck-fdc.o gets an other as the expected
number 0x00 or 0xf0 (I think so). (was subject: IOMEGA ditto 800
parport-problem on this mailinglist)
Make dmesg (if normal or full debug-message mode is enabled in MCONFIG of
ftape) and see what it means.
CU
Rico
PS: I hope anybody could help us with.
--
Rico Barth
E-Mail: [EMAIL PROTECTED]
[EMAIL PROTECTED]
W3: http://www.mathe.tu-freiberg.de/~barth/
