Hi there, > what do you mean "install"
Installed from binary RPM, which installs OK, but the binary segfaults as mentioned previously... > did you compile? After removing the binary RPM yes, firstly with SRPM, then after that failed to complete I tried again with tar.gz version... > what is causing the segfault? > > have you run it with strace? The last line is this... upeek: ptrace(PTRACE_PEEKUSER,8333,44,0): Operation not permitted [EMAIL PROTECTED] Downloads]# Other than that it has a number of 'No such file or dir' messages relating to Gtk files, and some more relating to various incarnations of libpthread.so.x (libpthread.so does exist but not with a numerical suffix) > It seems you have been pointed to a number of solutions, and not tried > them. Thats a rough call. Much of what I'm trying to figure out here I would believe is the domain of a knowledgable programmer...something I am not. I have tried all suggestions put forward from CLUG, as well as others I had read elsewhere... It is obvious to me that something about Iscan prevents many users from being able to run it. The forums on the Epson website are chock with messages from people having the same problems as me, and collectively no-one has been able to figure out a solution that is able to cure the problems for all. Its just frustrating that after spending that much money on good faith ( and seeing some reward for it under Mandrake 9.0) that I cannot continue to enjoy that under Mandrake 9.1 There will be a solution sometime, but perhaps the Windows drivers are the only one for me currently? This is no flame-bait...I need to use that scanner at its best quality asap... Kind regards, Chris Wilkinson, Christchurch.
