I found digikey has the same part, so now the digikey order has everything.
Combined/total cost for everything in the finished cable is a little high, but, I think I still prefer that to putting wear on the original cable with that sharp flex point at the db25 end. -- bkw On Fri, Jun 7, 2019, 12:55 AM Brian White <[email protected]> wrote: > These hoods from mouser came in, and they are perfect. > > So, if you're willing to deal with crimping pins for a dupont style > connector, the Rick Shear pcb fits in this housing with no grief, and the > assembled housing fits in a Model 100 with no problem and no hacking needed. > > https://photos.app.goo.gl/MN3VEmhEbqehxEzh8 > > Scroll to the end. > > I'm still trying to make a new tiny pcb that goes on the tpdd instead, and > you solder a factory molded serial cable to that, but until I get that, > Rick's existing pcb plus this enclosure (and this digikey order minus the > hoods) works great and supports all models and doesn't look too shabby > either. > > So that's a tolerably doable tpdd cable recipe on the books, a little more > realistic and straight-forward than the raw Marty Goodman schematic. > > http://tandy.wiki/TPDD#Cable > > Thanks Rick and Mike. > > -- > bkw > > On Sat, Jun 1, 2019, 5:32 PM Mike Stein <[email protected]> wrote: > >> Mouser shows a couple that look like they might fit: >> >> >> https://www.mouser.ca/ProductDetail/HARTING/09670250513?qs=sGAEpiMZZMu5A18b%252BIx2GqJxiHQ0oido%2FVfUIPfHQk4%3D >> >> >> https://www.mouser.ca/ProductDetail/HARTING/09670250411?qs=sGAEpiMZZMu5A18b%252BIx2GqJxiHQ0oido1QO%2FNnySBX8%3D >> >> ----- Original Message ----- >> *From:* Brian White <[email protected]> >> *To:* Model 100 Discussion <[email protected]> >> *Sent:* Saturday, June 01, 2019 1:19 PM >> *Subject:* [M100] dsub 25 hood that fits >> >> Anyone ever find a dsub 25 hood that fits in the serial port openeing on >> M100? >> >> -- >> bkw >> >>
